ROAD DECOMMISSIONING Sample Clauses

ROAD DECOMMISSIONING. The Forest Service will be responsible for decommissioning roads no longer needed. The parties agree that the Forest Service will prepare a comprehensive Road Decommissioning Plan and make every effort to obtain funds to complete the road decommissioning program in the Bull Run within 10 years.3 The parties desire to eliminate unnecessary roads as quickly as can be prudently managed commensurate with other priorities in the Pacific Northwest Region for the Forest Service, being sure to maintain adequate protections for water quality until this work is completed. The City will support federal funding requests to help facilitate this effort.
Sample 1Sample 2
ROAD DECOMMISSIONING. In cooperation with USDA-FS, PacifiCorp has identified PacifiCorp-Maintained Hydro Roads and PacifiCorp-Maintained Transmission Roads in need of decommissioning as shown on attached Schedule 15.4. The listed road segments, totalling 8.6 miles of road, will be decommissioned by PacifiCorp according to the USDA-FS Manual and Handbook provisions cited in Section 15.2 above and shall be completed by the fourth anniversary of the New License. If PacifiCorp, USDA-FS, and BLM agree, alternate road segments with approximately the same decommissioning cost as those listed may be substituted for decommissioning. Any PacifiCorp-Maintained Hydro Road or PacifiCorp-Maintained Transmission Road that PacifiCorp determines is no longer needed for Project operation by PacifiCorp shall be decommissioned as soon as is practicable according to the same standards.
Sample 1
ROAD DECOMMISSIONING. Contractor shall decommission the following roads at the termination of use within 30 days following completion of timber haul. E1030 1+00 to 18+60 Light E1032 0+00 to 16+50 Light M1840 0+00 to 11+43 Light M1857 2+10 to 16+30 Light
Sample 1
ROAD DECOMMISSIONING. The following roads shall be decommissioned by the Purchaser at the termination of use in accordance with Clause 9‐22 LIGHT DECOMMISSIONING. L‐1500G 0+00 to 11+08 LIGHT L‐1552D 0+00 to 9+56 LIGHT
Sample 1
ROAD DECOMMISSIONING. Purchaser shall decommission the following roads at the termination of use.
Sample 1
ROAD DECOMMISSIONING. Purchaser shall decommission the following roads before the termination of this contract. Purchaser shall abandon the following roads before the termination of this contract. Work must be in accordance with the ROAD ABANDONMENT CROSS SECTIONS DETAIL. W−1701 0+00 to 5+50 Light W−1701A 0+00 to 10+40 Light ▪ Construct non−drivable waterbars according to the attached NON−DRIVABLE WATERBAR DETAIL at a maximum spacing that will produce a vertical drop of no more than 10 feet between waterbars or between natural drainage paths and with a maximum spacing of 100 feet, or as marked in the field. ▪ Skew waterbars at least 30 degrees from perpendicular to the road centerline on roads in excess of 3 percent grade. ▪ Key waterbars into the cut−slope to intercept the ditch. Waterbars must be outsloped to provide positive drainage. Outlets must be on stable locations. ▪ Block roads with earthen barricades in accordance with the attached EARTHEN BARRICADE DETAIL. ▪ Remove temporary stream culvert and fill material in accordance with Clause 9−2 CULVERT REMOVAL FROM LIVE STREAM, and CULVERT FILL REMOVAL DETAIL. ▪ Remove ditch cross drain culverts and leave the resulting trench open. ▪ Slope all trench walls and approach embankments no steeper than 1.5:1. ▪ Apply grass seed concurrently with abandonment and in accordance with Section 8 EROSION CONTROL. ▪ Provide and evenly spread a 6−inch layer of straw to all exposed soils associated with stream culvert and puncheon removals, as well as all waste material generated by fill removal that is within 30 feet of excavation limits.
Sample 1
ROAD DECOMMISSIONING. Contractor shall decommission the following roads before the termination of this contract. E293905F All access to culverts listed below shall be from the newly constructed E293905L road where it intersects with the existing abandoned E293905F road. 17+41 Remove existing 18 in x 30 ft CMP, if CMP is not damaged during removal CMP can be re-used 19+44 Remove existing 18 in x 30 ft CMP, if CMP is not damaged during removal CMP can be re-used 21+70 Remove existing 24 in x 40 ft CMP, if CMP is not damaged during removal CMP can be re-used 26+20 Remove existing 18 in x 32 ft CMP, if CMP is not damaged during removal CMP can be re-used 29+50 Remove existing 18 in x 30 ft CMP, if CMP is not damaged during removal CMP can be re-used If culverts are undamaged and are not used elsewhere in the timber sale the culverts shall become property of the state and shall be delivered to the Colville work center
Sample 1
ROAD DECOMMISSIONING. Purchaser shall decommission the following roads within 30 days following completion of timber haul. Purchaser shall abandon the following roads before the termination of this contract.
Sample 1

Related to ROAD DECOMMISSIONING

  • Decommissioning (a) The Contractor shall submit to the Designated Authority, for its approval, pursuant to sub-paragraph 4.11(d)(v), a Decommissioning Plan for the Development Area and a schedule of provisions for the Decommissioning Costs Reserve. (b) The Decommissioning Plan shall be revised and resubmitted to the Designated Authority for its approval at such times as are reasonable having regard to the likelihood that the Decommissioning Plan (including cost estimates thereunder) may need to be revised. (c) The Contractor shall carry out the Decommissioning Plan substantially in accordance with its terms. (d) Estimates of the monies required for the funding of the Decommissioning Plan shall be charged as Recoverable Costs beginning in the Calendar Year following the Calendar Year in which Commercial Production first occurs. The amount charged in each Calendar Year shall be calculated as follows: (i) The total Decommissioning costs at the expected date of Decommissioning shall first be calculated. (ii) There shall be deducted from such total Decommissioning costs the additions made to the Decommissioning Costs Reserve made, and taken as Recoverable Costs, in all previous Calendar Years together with interest on such Recoverable Costs calculated to the approved date of Decommissioning at the actual or forecast rate of Uplift (whichever is applicable). (iii) The residual Decommissioning costs, resulting from the calculations under sub-paragraph 4.14(d)(i) and (ii), shall then be discounted to the Calendar Year in question at the forecast rate of Uplift for each Calendar Year remaining until the Calendar Year of Decommissioning. (iv) The discounted total of residual Decommissioning costs shall then be divided by the total number of Calendar Years remaining prior to the Calendar Year of Decommissioning itself, including the Calendar Year in question. (v) The resultant amount shall be the addition to the Decommissioning Costs Reserve for the Calendar Year in question. (vi) It is the intention of this provision that the total accumulated provision allowed, including interest calculated to the Calendar Year of Decommissioning at the rate of Uplift, will equal the total Decommissioning costs. (vii) If the amount in sub-paragraph 4.14(d)(v) is a negative amount, then such amount shall be treated as a reduction of Recoverable Costs for the Calendar Year in question.

  • Commissioning Commissioning tests of the Interconnection Customer’s installed equipment shall be performed pursuant to applicable codes and standards. The ISO and Connecting Transmission Owner must be given at least five Business Days written notice, or as otherwise mutually agreed to by the Parties, of the tests and may be present to witness the commissioning tests.

  • Construction Phase Services 3.1.1 – Basic Construction Services

  • Synchronization, Commissioning and Commercial Operation 5.1.1 The SPG shall give PGVCL at least thirty (30) days’ advanced preliminary written notice and at least fifteen (15) days’ advanced final written notice, of the date on which it intends to synchronize the Solar Power Project to the Grid System. 5.1.2 Subject to Article 5.1.1, the Power Project may be synchronized by the SPG to the Grid System when it meets all the connection conditions prescribed in applicable Grid Code then in effect and otherwise meets all other Indian legal requirements for synchronization to the Grid System. 5.1.3 The synchronization equipment and all necessary arrangements / equipment including RTU for scheduling of power generated from the Project and transmission of data to the concerned authority as per applicable regulation shall be installed by the SPG at its generation facility of the Power Project at its own cost. The SPG shall synchronize its system with the Grid System only after the approval of synchronization scheme is granted by the head of the concerned substation/ and checking/verification is made by the concerned authorities of the PGVCL. 5.1.4 The SPG shall immediately after each synchronization/tripping of generator, inform the sub-station of the Grid System to which the Power Project is electrically connected in accordance with applicable Grid Code. In addition, the SPG will inject in-firm power to grid from time to time to carry out operational/ functional test prior to commercial operation. For avoidance of doubt, it is clarified that Synchronization / Connectivity of the Project with the grid shall not to be considered as Commissioning of the Project. 5.1.5 The SPG shall commission the Project within nine (9) Months from the Date of execution of this PPA. Declaration of COD shall be certified by the commissioning committee. 5.1.6 The Parties agree that for the purpose of commencement of the supply of electricity by SPG to PGVCL, liquidated damages for delay etc., the Scheduled Commissioning Date as defined in this Agreement shall be the relevant date.

  • Participating TO’s Interconnection Facilities The Participating TO shall design, procure, construct, install, own and/or control the Participating TO’s Interconnection Facilities described in Appendix A at the sole expense of the Interconnection Customer. Unless the Participating TO elects to fund the capital for the Participating TO’s Interconnection Facilities, they shall be solely funded by the Interconnection Customer.

  • Network Interconnection Architecture Each Party will plan, design, construct and maintain the facilities within their respective systems as are necessary and proper for the provision of traffic covered by this Agreement. These facilities include but are not limited to, a sufficient number of trunks to the point of interconnection with the tandem company, and sufficient interoffice and interexchange facilities and trunks between its own central offices to adequately handle traffic between all central offices within the service areas at a P.01 grade of service or better. The provisioning and engineering of such services and facilities will comply with generally accepted industry methods and practices, and will observe the rules and regulations of the lawfully established tariffs applicable to the services provided.

  • Installation, Maintenance, Testing and Repair Unless otherwise agreed in writing by the Parties, to the extent required by Applicable Law, Interconnection provided by a Party shall be equal in quality to that provided by such Party to itself, any subsidiary, affiliates or third party. If either Party is unable to fulfill its obligations under this Section 14.2, it shall notify the other Party of its inability to do so and will negotiate alternative intervals in good faith. The Parties agree that to the extent required by Applicable Law, the standards to be used by a Party for isolating and clearing any disconnections and/or other outages or troubles shall be at parity with standards used by such Party with respect to itself, any subsidiary, affiliate or third party.

  • Generating Facility The Interconnection Customer’s device for the production of electricity identified in the Interconnection Request, but shall not include the Interconnection Customer’s Interconnection Facilities.

  • Connecting Transmission Owner’s Scope of Work and Responsibilities The Connecting Transmission Owner will design, construct, own, operate and maintain all Connecting Transmission Owner’s Interconnection Facilities, except as otherwise stated above and in the Project Specific Specifications. The Connecting Transmission Owner will complete all engineering reviews, field verifications and witness testing, etc. in accordance with the ESBs and the Project Specific Specifications. Connecting Transmission Owner shall provide the revenue metering CT/PT units and meter socket enclosure. The Connecting Transmission Owner shall: • provide, run, and wire both ends of the color-coded cable for the revenue metering instrument transformer secondary wiring; • perform all terminations; and • supply and install the meter. The revenue meter may require a communications link to the RTU. The Connecting Transmission Owner will specify and run those communications cables. The Connecting Transmission Owner shall complete all wiring, testing and commissioning of the RTU.

  • Stormwater Notwithstanding any other provisions or terms of this Agreement, Company acknowledges that certain properties within the Premises or on Authority-owned land are subject to stormwater rules and regulations. Company agrees to observe and abide by such stormwater rules and regulations as may be applicable to the Premises, and, if applicable, Company hereby expressly covenants, warrants, and represents to Authority, in connection with Company’s operations on the Premises, the following: A. Company is required to submit a Notice of Intent to use the State of Florida Multi-Sector Generic Permit for Stormwater Discharge Associated with Industrial Activity. Authority and Company both acknowledge that close cooperation is necessary to ensure compliance with any stormwater discharge permit terms and conditions, as well as to ensure safety and to minimize the cost of compliance. Company acknowledges further that it may be necessary to undertake actions to minimize the exposure of stormwater to “significant materials” (as such term may be defined by applicable stormwater rules and regulations) generated, stored, handled, or otherwise used by Company by implementing and maintaining “best management practices” (BMPs) (as such term may be defined in applicable stormwater rules and regulations). Company will establish a BMP plan for the Premises and submit a copy to Authority. B. Company will be knowledgeable of any stormwater discharge permit requirements applicable to Company and with which Company will be obligated to comply. The submittal of a Notice of Intent will be made by Company to the FDEP, and a copy will be submitted to Authority. Company is required to comply with the following requirements including, but not limited to, certification of non-stormwater discharges; collection of stormwater samples; preparation of a Stormwater Pollution Prevention Plan or similar plans; implementation of BMPs; and maintenance and submittal of necessary records. In complying with such requirements, Company will observe applicable deadlines set by the regulatory agency that has jurisdiction over the permit. Company agrees to undertake, at its sole expense, those stormwater permit requirements for which it has received written notice from the regulatory agency and that apply to the Premises, and Company agrees that it will hold harmless and indemnify Authority for any violations or non-compliance with any such permit requirements.

OSZAR »